Motech LPS 305 Bedienungsanleitung PDF herunterladen (Seite 8)

2. INSTALLATION

2.1 Introduction

This section contains instructions for checking and mounting your power supply and connection your

power supply to AC power.

The power supply generates operating magnetic which may affect the operation other instruments. If

your instrument is susceptible to operating magnetic fields, position it more than three inches from the

power supply.

2.2 Initial inspection

Your supply was thoroughly inspected and tested before shipment. As soon as toy receive it, remove it

from its packaging case and check to make sure it has not been damaged during shipment, Check

that there are no broken connectors or keys and that the cabinet and panel surfaces are free from

dents and scratches,

2.3 Location and cooling

Your power supply can operate without sacrificed performance within the temperature range of 0 to 40

℃ (measured at the fan intake). The fan, located at the rear of the unit, cools the supply by drawing

air in through the openings on the sides and exhausting it through the opening on the rear panel,

Since the power supply is fan cooled, it must be installed in a location that allows sufficient clearance

of 1 inch (25mm) is required on all sides for proper ventilation,

2.4 Input power requirements

You can operate this power supply from a nominal 115V or 230(240) Vac single phase power source

at 47 to 63Hz. You can check the line voltage setting of your supply of your supply by examining the

label on the rear panel.

2.5 Line fuse

You can operate this located behind the fuseholder on the QC input socket. To access the fuse,

remove the power cord and pull out the fuseholder on the AC input socket. The current ration of the

fuse is based on the line voltage setting of your supply.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 21 22

Keine Kommentare

Motech LPS 305 Bedienungsanleitung Seite 8